These eye bolts are primarily intended to be installed into tapped holes.ġ. Machinery Eye Bolt - Installation for In-line & Angular Loading When using lifting slings of two or more legs, make sure the loads in the legs are calculated using the angle from the vertical to the leg and properly size the shoulder nut or machinery eye bolt for the angular load.Never exceed the capacity of the eye bolt-see Table I & 2.Always apply load to eye bolt in the plane of the eye - not at an angle.Always lift load with steady, even pull - do not jerk.Regular Nut & Shoulder Nut Eye Bolt - Installation for In-line Loading IMPORTANT - Read and understand these instructions before using eye bolts. Shoulder Nut Eye Bolt - Installation for Angular Loading Always tighten nuts securely against the load.Always screw eye bolt down completely for proper seating.Always countersink receiving hole or use washer with sufficient I.D.
Never undercut eye bolt to seat shoulder against the load.For angular lifts, adjust working load as follows:.Always use shoulder nut eye bolts (or machinery eye bolts) for angular lifts.Never use regular nut eye bolts for angular lifts.Never exceed load limits specified in Table I & Table 2.Always be sure threads on shank and receiving holes are clean.Never use eye bolt if eye or shank is bent or elongated.Never use eye bolt that shows signs of wear or damage.Important Safety Information - Read & Follow Read, understand, and follow information in diagrams and charts below before using eye bolt assemblies.Read and understand both sides of these instructions, and follow all eye bolt safety information presented here.A falling load can seriously injure or kill.Loads may slip or fall if proper eye bolt assembly and lifting procedures are not used.
0 kommentar(er)
